I have compiled the newest version of rosetta3 in centos7 without any problem. After installation, I was testing the rosetta. Some errors occur. Could any one give me some suggestions?
Thank you for taking your time.
I have attached the test.log below.
Attachment | Size |
---|---|
errors | 161.85 KB |
Category:
Post Situation:
While I have compiled rosetta_2017.08.59291 and tested it in the same workstation. The errors cannot be found. However, some test failures can be observed. I have attached it below.
Any suggestion?
Would anyone have some valuable suggestions?
Thank you for taking your time.
Jacky
Are you running simpley test/run.py? Is this on a single processor or multiple?
Thank you for your reply. I have not run test/run.py on a single processor. However, I have tested rosetta_2017.39 and rosetta_2017.08 on mutipile processor.
Would you have any suggestions?
Thanks a lot
Jacky
As your suggestions, I have tested again by using a single processor. The same error can be observed. I have attached it below.
Thanks.